The bottle jack of China manufacturers has become an increasingly important product for people to use .It can not only help you lift the heavy stuff ,but also keep you safe.
In the daily life,users can also use it to lift the the heavy stuff to keep you safe.
It can assist you to complete lots of heavy work and make it easy for you.
how to make a decision to buy the most suitable hydraulic bottle jack can be referred to the following points.
1. How does bottle jack work?
There’s a hydraulic bottle jack positioned horizontally with the valving and stuff just a little bit different to make it all work so this can go right off the table.
Because there’s nothing here that isn’t in here so we inside all of these hydraulic rams you got your pump and you got your hydraulic cylinder and then you have a reservoir around the outside so inside there you have your ram centerpiece and they you’ll have a housing it slides up and down and then you just have reservoir fluid all the way around the outside that’s why there’s a little fill plug on all of these things.Because the outside .
It can be any size ,this one needs a little bit bigger to hold fluid around.because the middle piston is so full and so when the fluid level if this was clear as you pump it up the fluid lever drops from the outside it’s sucked into the pump and goes up into the hydraulic ram forcing it up and out to a point and it is able to do all this with the inside the tiny balls which is essentially just a little BB.
Use Of Fluid
The fluid actually helps push the ball against this surface with the springs help and fluid doesn’t want to go this way it wants to go through here up into our hydraulic ram with another check ball and this check ball over here gets pushed away and the fluid runs past it .
I’ve seen so many where people put the balls in backwards and they do absolutely nothing you know they do nothing you know they put them backwards and they do nothing you can’t get anything to them one of the reasons they fail is maybe the ball has some pittings or some you know some rust specs on it because water got in it,it’s not making a tight seal here so if you go to pump and it’s not really pumping up fluid could be running past this ball right here which is just located down in the bottom right here .it could just be pushing back so cliff taking the ball out cleaning the surface . We get know how the bottle jack works.
2. How to rebuild the bottle jack
We can start installing that what you’re going to have this particular one has a little just a set of plastic nylon kits.
They have to be good quality . sometimes it caused oil leak because of the nylon kits are not tough enough .After long time inside,they will get rotten.
So we have to take apart the bottle jack all the parts. And check the nylon repairt kits . if they are really getting rotten,you have to replace them with the new one.
3. The common cases with the bottle jack
Oil leaking.
It mainly from the base or from the pump side. It is the most common case in our life but also very important. Sometimes it happend by the labor when they assemble it not check carefully .
Also when the base come ,they not clean them very carefully .because when the base factory when finished the base mould they will not clean it .deep inside it left many dust inside ,once labor assemble them without cleaning ,it will be easy to get oil leaking.
Another one is if you put them in backwards for long time,it will be easy to get oil leaking.
The piston stuck
The bases are not cleaning enough and the balls are in the wrong position.
4.Comparison
Everyone’s favorite tool quality is different. Don’t preconceived by the information you read before.
Remember, the best bottle jack will never come out in real life.
you can only find the ones that work best for you based on demand and price.
